FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
22 01-30004-0266-20070831
Installing a PCMCIA card Installing the FortiGate unit
7 Select one of the following DNS settings:
• Obtain DNS server address automatically: select to get the DNS addresses
from the ISP, select Apply
• Use the following DNS server addresses: select and enter the DNS server
addresses given to you by the ISP, select Apply
8 Go to Router > Static, edit route #1 and change Gateway to the default gateway
IP address from the ISP and select OK.
Network configuration is complete. Proceed to “Set the date and time” on page 44.
9 Select Retrieve default gateway from server and Override internal DNS options if
your ISP supports them, select OK, and proceed to “Set the date and time” on
page 44.
Go to step 6 if you are not selecting these options.
Installing a PCMCIA card
The FortiGate-60B and FortiWiFi-60B include a PCMCIA card slot, enabling you
to expand the functionality of the device.
The devices support Type II PC Card based 3G wireless broadband and MiniPCI
Card based IEEE802.11b/g WiFi broadband. This enables you to establish
secure 3G/WiFi wireless broadband network access instantly without the need
for a fixed internet connection. FortiGate-60B also integrates a 2-port FXO VOIP
Card for low-cost VOIP communication.
To install a PCMCIA card
1 Shut down the FortiGate or FortiWiFi unit using the proper shutdown
procedure outlined in the section “Powering off the FortiGate unit” on
page 17.
2 Insert the card until it clicks into place.
3 Start up the FortiGate or FortiWiFi device.
To remove a PCMCIA card
1 Shut down the FortiGate or FortiWiFi unit using the proper shutdown
procedure outlined in the section “Powering off the FortiGate unit” on
page 17.
2 Press the eject button to the right of the card slot and remove the card.
3 Start up the FortiGate or FortiWiFi device.
60B
WiFi60B
To Next Page
Loading...
