Fortinet FortiGate FortiGate-100A - Connecting and Disconnecting the Modem in Stand Alone Mode

Configuring the modem interface Connecting and disconnecting the modem in Stand alone mode
FortiGate-60 series and FortiGate-100A FortiOS 3.0 MR4 Install Guide
01-30004-0266-20070831 53
You can configure and use the modem in NAT/Route mode only.
To configure modem settings
1 Go to System > Network > Modem.
2 Select Enable Modem.
3 Change any of the dial-up connection settings.
4 Enter the settings for Dial-up Account 1 settings.
5 If you have multiple dial-up accounts, enter Phone Number, User Name, and
Password for Dial-up Account 2 and Dial-up Account 3.
6 Select Apply.
Connecting and disconnecting the modem in Stand alone mode
To connect to a dial-up account
1 Go to System > Network > Modem.
2 Select Enable Modem.
3 Make sure there is correct information in one or more Dial-up Accounts.
4 Select Apply if you make any configuration changes.
5 Select Dial Now.
The FortiGate unit initiates dialing into each dial-up account in turn until the
modem connects to an ISP.
A green check mark indicates the active dial-up account.
The IP address and netmask are assigned to the modem interface. Go to
System > Network > Interface to verify the IP address and netmask.
To disconnect the modem
Use the following procedure to disconnect the modem from a dial-up account.
1 Go to System > Network > Modem.
2 Select Hang Up if you want to disconnect from the dial-up account.
not active The modem interface is not connected to the ISP.
active The modem interface is attempting to connect to the ISP, or is connected
to the ISP.