NVR configuration Page 24 FortiRecorder 2.4.2 Administration Guide
4. Configure these settings:
Setting name Description
Interface Select the name of the network interface where this DHCP server will
listen for requests from DHCP clients.
Gateway Type the IP address that DHCP clients will use as their next-hop
router.
On smaller networks, this is usually the same router that
FortiRecorder uses. It could be your office’s router, or cable/DSL
modem.
DNS options Select either:
• Default — Leave DHCP clients’ DNS settings at their default
values.
• Specify — Configure DHCP clients with the DNS servers that you
specify in DNS server 1 and DNS server 2.
DNS server 1 Type the IP address of a DNS server that DHCP clients can use to
resolve domain names. For performance reasons, if you have one, it
is preferable to use a DNS server on your local network.
This setting is available only if DNS options is set to Specify.
DNS server 2 Type the IP address of an alternative DNS server that DHCP clients
can use to resolve domain names. For performance reasons, if you
have one, it is preferable to use a DNS server on your local network.
This setting is available only if DNS options is set to Specify.
Domain Optional. Type the domain name, if any, that DHCP clients will use
when resolving host names on the local domain.
Netmask Type the subnet mask that DHCP clients will use in conjunction with
the IP address that is assigned by FortiRecorder’s DHCP server.
To Next Page
Loading...