Appliance Setup
Regardless of whether you select FortiSIEMManager,Supervisor, Worker, or
Collector, you will see the same series of screens with only the header changed to reflect
your target installation, unless noted otherwise.
8. If you want to enable FIPS, then choose 2. Otherwise, choose 1. You have the option of enabling FIPS (option 3) or
disabling FIPS (option 4) later.
Note: After Installation, a 5th option to change your network configuration (5 change_network_config) is
available. This allows you to change your network settings and/or host name.
FortiSIEM 6.6.2 2000G Hardware Configuration Guide 8
Fortinet Inc.
To Next Page
Loading...
