Appliance Setup
9. Determine whether your network supports IPv4-only, IPv6-only, or both IPv4 and IPv6 (Dual Stack). Choose 1 for
IPv4-only, choose 2 for IPv6-only, or choose 3 for both IPv4 and IPv6.
10. If you choose 1 (IPv4) or choose 3 (Both IPv4 and IPv6), and press Next, then you will move to step 11. If you
choose 2 (IPv6), and press Next, then skip to step 12.
11.
Configure the network by entering the following fields. Note the IP Address--you will need it in a later step. Press
Next.
Option Description
IPv4 Address The Manager/Supervisor/Worker/Collector's IPv4
address
NetMask The Manager/Supervisor/Worker/Collector's
subnet
Gateway Network gateway address
DNS1, DNS2 Addresses of the DNS servers
12. If you chose 1 in step 9, then you will need to skip to step 13. If you chose 2 or 3 in step 9, then you will configure
the IPv6 network by entering the following fields, then press Next.
FortiSIEM 6.6.2 2000G Hardware Configuration Guide 9
Fortinet Inc.
To Next Page
Loading...
