21
Foam is overflowing from the detergent drawer
Too much detergent is used.
Mix 1 tablespoonful softener and ½ L water and pour into the main wash compartment of the detergent
drawer.
Put detergent into the washer suitable for the programmes and maximum loads indicated in the “Programme
table”. When additional chemicals (stain removers, bleachs and etc) are used, reduce the amount of
detergent.
Laundry remains wet at the end of the programme
Excessive foam might have occurred and automatic foam absorption system might have been activated due
to too much detergent usage.
Use recommended amount of detergent.
To prevent any damage to the washer and to its surrounding environment, washer will not switch to
spinning step if the laundry is not evenly distributed in the drum. Laundry should be rearranged and
re-spun.
Warning: If the problem still cannot be eliminated after following the instructions in this section,
consult the authorized service agent. Never try to repair a non-functional washer yourself.
SPECIFICATION
FW1215C718
Maximum capacity (dry laundry)
7 kg
56.5 cm
70 kg
Rated Voltage / Frequency
1200 rpm
0.25 W
Single water inlet / Double water inlet
Available
Technical specifications may be changed without prior notice to improve the quality of the appliance.
Figures in this manual are schematic and may not match the appliance exactly.
Values stated on the washer labels or in the documentation accompanying it are obtained in laboratory
conditions in accordance with the relevant standards. Depending on operational and environmental
conditions of the appliance, these values may vary.
To Next Page
Loading...
Need help?
General
