EasyManuals Logo

Fortress Technologies FW1215C718 User Manual

Fortress Technologies FW1215C718
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
17
MAINTENANCE INSTRUCTION
Service life of the appliance extends and frequently faced problems decrease if cleaned at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every 4-5 washing cycles) as shown below in order to prevent
accumulation of powder detergent in time.
1. Press the dotted point on the siphon in the softener compartment and pull towards until the compartment is
removed from the washer.
If more than normal amount of water and softener mixture starts to gather in the softener compartment,
the siphon must be cleaned.
2. Wash the detergent drawer and the siphon with plenty of lukewarm water in a washbasin. Wear protective
gloves or use an appropriate brush to avoid touching the residues in the drawer with the skin when cleaning.
3. Insert the drawer back into its place after cleaning and make sure that it is seated well.
If your detergent drawer is the one indicated in the following figure:
Lift the rear part of the siphon to remove it as illustrated. After performing the above mentioned
cleaning procedures, replace the siphon back to its seating and push its front section downwards to
make sure that the locking tab engages.
The appliance is equipped with a “Standby Mode”
After you switch on your machine with On-Off button, if no programme is started or no other procedure is performed at the
selection step or no action is taken within approx. 2 minutes after the selected programme ends, your machine will switch to
energy saving mode automatically.
The brightness of the indicator lights will decrease. Also, if your product has a display that shows programme time, this display
will be completely turned off. If you turn the Programme Selection knob or touch any button, lights and display will switch
back to previous condition. The selections which you make when exiting from the energy efficiency may change. Please check
the correctness of your selections before starting the programme. If necessary, please make your settings again. This is not an
error.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fortress Technologies FW1215C718 and is the answer not in the manual?

Fortress Technologies FW1215C718 Specifications

General IconGeneral
BrandFortress Technologies
ModelFW1215C718
CategoryWasher
LanguageEnglish

Related product manuals