5
There are two options in the following steps, please pay attention to choose the
corresponding adding method.
7. Please wait for a few seconds, you can tap "Configure WiFi" in "Configure WiFi"
interface, then select your WiFi network and enter your WiFi's password. After,
you can set the camera name and tap “Save” in "Set name" interface.
Note: It is strongly recommended that you choose to configure WiFi at this step.
8. Please wait for a few seconds, you can tap "Configure WiFi" in "Configure WiFi"
interface, then you tap "Skip" in the "WiFi Settings" interface. After, you can set
the camera name and tap “Save” in "Set name" interface.
Note: If the adding process fails, please reset your camera and try adding again
according to the above method.
9. Tapping on the play button in the video box will jump to the “Camera Login”
setting interface. For your security, please set a new username and password for
your camera before viewing live video.
10. After completing the above steps, you can begin using your camera
Note: If you choose installation step 8, please refer to the following steps for configuring
WiFi. After setting your WIFi, you can unplug your network cable and the camera works
normally.
Configure WiFi
If you selected "Skip" in step 8, click play to enter the camera credentials interface > Tap
the “gear” button > tap “WiFi Settings” > select your WiFi network and enter your WiFi’s
password. After setting up successfully, you can view live video without the Ethernet
cable.
To Next Page
Loading...
