1.5 SD Card Management
This camera supports Micro SD Card.
When you plug in the SD card during the camera work process, please reboot the camera again, or else the
SD card might not work well.
On Foscam app go to the SettingsDevice StatusDevice Status page, you can see the SD card status.
1.6 Add Device: Connection via the Foscam App
Scan the QR code below to download and install the Foscam APP.
Please refer to the Quick Setup Guide.
1.7 Installation
Please refer to the Quick Setup Guide.
Point the camera at the desired location and use the screws provided to mount it.
Please Note:
Ensure that rain or water will not reach the connector ports at the end of the pig tail wiring. These connectors
are not weather-resistant.
1.8 Waterproof Lid Installation Guide
When mounting your camera outdoors, you are suggested to install the waterproof lid for it. You may follow the
steps for installation.
1. Thread the Ethernet cable through the top cover and then the waterproof connector.
To Next Page
Loading...
Need help?
General
