D-160 Owner's Manual (MIDI sync function)
119
* If correct sync cannot be obtained, re-check the connections/cables and setting
of both equipment.
<Note>
In the D-160, the "ABS 0" position is set at "002BAR/1BEAT /00CLK."
This setting is made in consideration of the time required (it will not sync immediately)
for the MIDI sequencer, etc. to enter into sync.
As a result, if the D-160 is played back from ABS 0 (LOCATE ABS 0), sync will be
completed by the time it reaches the first bar, and will thus synchronize from head
of the tune.
Execution of recording
Various ways of recording can be conducted while synchronizing the D-160 and
the MIDI sequencer with the MIDI clock.
To Next Page
Loading...
