D-160 Owner's Manual (Recording/Playback)
66
Setting a digital mixer
1
. Select the internal clock (INTERNAL).
2
. Set the mixer so that it will be able to accept a digital input signal.
* Refer to the instruction manual that came with the external digital device.
Setting the D-160
1
. Select a Program.
* Refer to “2-2. Program Change” for the procedure and details.
2
. Set a sampling rate.
Set the sampling rate of the D-160 to that of the digital mixer.
* Refer to “2-4. Setting a sampling rate” for the procedure and details.
3
. Set the digital input track in Setup mode according to the type of the digital input signal.
* Refer to “2-15. Digital input track setting in Setup mode” on page "157" for
the procedure and details.
4
. Set the digital output signal in the digital output track parameter in Setup mode.
* Refer to “2-16. Digital output track setting in Setup mode” on page "159" for
the procedure and details.
<Note>
When you set up a digital input track, the settings for the external sync signal of
the “Slave mode type setting” in Setup mode (that is, Vari, S/P DIF, adat, and Free)
will be ignored, and the D-160 will sync to the specified digital input signal. Refer
to “2-13. Slave mode type setting” in Setup mode on page "155" for more
information.
To Next Page
Loading...
