Fostex VF08 - Page 46

46
Mixer Functions
Chorus effect parameters (parameter type: CHORUS)
For effect type 35 of the preceding "Effect type" table, the following four parameters can be adjusted.
1. Eff Level Adjust the effect return level: 0~99
2. Depth Adjust the chorus depth. Range: 0--99
3. Double Time Adjust the time difference of the doubling effect. Range: 0--99
4. Double Lvl Adjust the volume of the doubling effect. Range: 0--99
5. Filter Adjust the tone of the delay sound. Range: L9~L1, OFF, H1~H9
* L1~L9 = LPF (larger numbers will lower the cutoff frequency)
* H1~H9 = HPF (larger numbers will raise the cutoff frequency)
Flanger effect parameters (parameter type: FLANGE)
For effect type 36 of the preceding "Effect type" table, the following four parameters can be adjusted.
1. Eff Level Adjust the effect return level: 0~99
2. Rate Adjust the speed of modulation. Range: 0.01--2.00 Hz
3. Depth Adjust the depth of modulation. Range: 0--99
4. Mod Delay Adjust the modulation delay. Range: 0--200
5. Feedback Adjust the number of modulation repeats. Range: 0--99
Delay pitch effect parameters (parameter type: DELAY PITCH)
For effect type 38 of the preceding "Effect type" table, the following four parameters can be adjusted.
1. Eff Level Adjust the effect return level: 0~99
2. Pitct Adjust the amount of pitch shift. Range: -24--0--+24
* +/-12 is one octave. +/-24 is two octaves.
3. Adjust Make fine adjustments to the amount of pitch shift. Range: -50--0--+50
* +50 is a semitone sharp. -50 is a semitone flat.
4. Delay Time Adjust the delay time until the pitch-shifted sound is heard. Range: 0--500 ms
5. Feedback Adjust the number of delay repeats. Range: 0--99
Mono pitch effect parameters (parameter type: MONO PITCH)
For effect type 37 of the preceding "Effect type" table, the following three parameters can be adjusted.
1. Eff Level Adjust the effect return level: 0~99
2. Pitch Adjust the amount of pitch shift. Range: -24--0--+24
* +/-12 is one octave. +/-24 is two octaves.
3. Adjust Make fine adjustments to the amount of pitch shift. Range: -50--0--+50
* +50 is a semitone sharp. -50 is a semitone flat.
4. Mode Select the processing method. Range: 1--3