71
Advanced Operation
OFF
ON
MIDI
OUTPUT INPUT OUTPUT
INPUT
POWER
PHANTOM
S/P DIF / DATA
Digital master recorder
Analog master recorder S/P DIF DATA OUTPUT
ST OUT L, R
1
Effect library
EQ
Ambience
Compressor
High Gain
Mid Gain
Low Gain
Rev Level
Rev Time
Pre Delay
Threshold
Ratio
Gain
Atack
Copy Protect
Mastering mode
You can use Tracks 7/8 as the mastering tracks.
After performing the track bouncing to mix down track signals to Tracks 7/8, you can record the audio signals
on Tracks 7/8 to an external (analog or digital) master recorder with applying effects for mastering (see the il-
lustration below).
You can perform the above operation in the mastering mode, which can be selected by the [MASTERING] key.
When the mastering mode is active, only Tracks 7/8 can be played back, while the dedicated effects for master-
ing are available. In the following description, we assume that the stereo mix signals are recorded on Tracks 7/
8.
Selecting a program to be played back
If there are more than one program in the VF08, se-
lect the desired program to be played back.
See "Selecting a program" for the operation.
On/off of mastering mode
Press the [MASTERING] key.
Each press of the [MASTERING] key alternates ON and
OFF of the mastering mode.
When setting to ON, the [MASTERING] key is illuminated
and the following screen is displayed, while the [TRACK
STATUS/TRACK SEL] key of Track 7/8 and the [STATUS/
SEL] key for the master are illuminated in green.
The screen example above shows the upper part of the
mastering effects setting. Pressing the [CURSOR down]
key scrolls down the setting items. To scroll up, press
the [CURSOR up] key.
The table below shows the items and functions of the
mastering effects.
You can select a desired preset entry
from 10 entries stored in the effect library.
See "Effect library details" on the next
page.
Adjusts the EQ gain for the high fre-
quency range within a +/- 18 dB range.
Freq. and Q: fixed
Adjusts the EQ gain for the middle fre-
quency range within a +/- 18 dB range.
Freq. and Q: fixed
Adjusts the EQ gain for the low fre-
quency range within a +/- 18 dB range.
Freq. and Q: fixed
Adjusts the amount of reverb sound be-
tween 0 and 99.
Fixed (See “Effect library details” on the
next page.
Fixed (See “Effect library details” on the
next page.
Adjusts the threshold of the compres-
sor between -50 dB and 0 dB in 1 dB
steps.
Selects the compressor ratio from the
following options.
∞:1, 20:1, 10:1, 8:1, 6:1, 5:1, 4:1, 3.5:1,
3:1, 2.5:1, 2:1, 1,7:1, 1.5:1, 1.3:1, 1.1:1,
1:1
Adjusts the compressor gain between
0 dB and +18 dB.
Selects ON or OFF of the copy protec-
tion for the S/P DIF output signal.
When set to ON, the flag for limiting a
digital copy to one generation is set in
the S/P DIF digital output signal.
To Next Page
Loading...
Need help?
General
