Fostex XR-3 - Page 14

CHAPTER Vi Basic Guide "Let's Start Recording"
If you are recording data to any track other than T rack 1, change the INPUT jack and the REC
SEL button setting as shown in the following table:
Re co rdfi n g; UT ;|aic k
2
REC SEL button setting
REC i-i,
SB. 0L [HR !
0 1
Q Bounce
Channel 2
i till
•— o
cm • cm
• O 1 o
REC i—i,
SEL mu
UlR !
1 H
Q Bounce
Channel 1
[ cm
'— O
CCD | cm
□ XI
o 1 1 • o
sel El
0R
□
D Bounce
Channel 2
. cm
L-O
cm
o
cm
o
cro
•
connected to the INPUT jack!
.iiummmmmmmmimf usr One-Point Advice! ^nimm..
You can connect two instruments to different INPUT jacks to record on two tracks
simultaneously. In this case, remember the following relationship between the INPUT jack
and recording track.
The instrument connected to Channel 1 will be recorded to T rack 1 or Track 3 depending on the REC
SEL button setting. The instrument connected to Channel 2 will be recorded to Track 2 or Track 4
depending on the REC SEL button setting.
<Notes on the REC SEL button>
When you are recording two tracks simultaneously, turning off (punch out) one of the
REC SEL buttons may cause a click noise to be recorded on the tape, spoiling your
valuable recording. Be careful if you wish to operate the REC SEL buttons during
recording.