Fostex XR-3 User Manual

The following table shows the settings of the INPUT jacks, Input Level switches, the REC
SEL buttons, and GAIN and PAN controls during the basic overdubbing operation (Step 1
-Step 4). Refer to this table for Step 1-4 operation.
INPUT jack
Input Level switch
GAIN and PAN (Monitor section)
Step 1
Channel 1
Channel 1 -» HIGH
SEL CQl I [3 n. 1 21 1 Hsoooco
r on cm j rrn OH
1 O 1 O 1 0
Step 2
Channel 2
Channel 2 -> MID
SEt 0L 1 CO A 1 D 1 QSouncd
I cm J cm rm m3
•— o 1 • 1 o 1 o
Step 3
Channel 1
Channel 1 -» M ID
SEL tDL 1 Efi I D 1 □ flounce
1 ■ ■ ■ ■ 1 ■ » ■ i 1 rrn 1 1111
1 0 1 • 1 o
Step 4
Channel 2
Channel 2 -»@
/'Set this switch to “LOWn
when you are using an
V. external microphone. J
SEL Ql I 0R f fl 1 QBrXmce
i cm cm cm am
o 1 o 1 o 1 •
TRACK 1 TRACK 2 TRACK 3 TRACK 4
L^R U \\ l — n
iimiimiiiiiimimiimiiiiimmiimm ^ i Bg* One-Point Advice 1 ii n n imiiiiiiniiiiiiiii
Be careful when you are setting the REC SEL buttons for the overdubbing steps. One
incorrect setting may destroy your efforts.
mmmmiiimiiiiiiiiiiiiiiiimuiiiimn ^c^^ One«Point AdvicesT ) i iiiiiii i m i i ii t i ii i m iiiiiii m iiii mmm
The settings of the monitor section (GAIN & PAN) shown in the table above are just an
example. You can set the playback level lower, and the recording level higher. You can also
pan all sounds to the center for monitoring. Adjust the GAIN and PAN controls to suit your
taste.
Listening to the recorded tracks
When you finish recording the song to the tracks, let's listen to the result.
IT! Rewind the tape to the beginning.
|~2~1 Turn alt the REC SEL buttons OFF.
3
4
5
6
Set the METER SEL switch to "L/R."
Press the PLAY button to start playback.
Adjust the track volume level and balance using the Track 1-4 GAIN control and PAN
control, respectively.
Raise the MASTER fader gradually, and you will hear the sound of each track.
19

Fostex XR-3 Specifications

General

Brand	Fostex
Model	XR-3
Category	Recording Equipment
Language	English