Fostex XR-3 User Manual

Mixdown
5
Locate the beginning of the tape.
6 .
Start recording on the master recorder first.
Vi ] Press the PLAY button on the XR-3 to start mixdown.
iiiiiiniiHiimiiiiiiiiiiiiiiiiiiiiiiiiimiii ^i]^ One-Point Advice I^ MiiMiiiiiiiiiiiiiimiiimiiiiiiiiiiiimmi
Applying reverb to the vocal sound on Track 4 during mixdown.
1. Connect the TAPE OUT jack 4 to the INPUT connector on the reverb unit.
2 . Connect the OUTPUT connector on the reverb unit to the XR-3's Channel 1 INPUT jack
(because we recorded the vocal part with the PAN control set to "L"). (All the REC SEL
buttons remain OFF.)
3. Use the Channel 1 INPUT fader to adjust the level of the signal input from the reverb unit.
4. Start mixdown.
You can mixdown with reverb applied to the vocal sound.
miiiimmiiimimiiiiiiiiiiiiiiiimimi ^ i isi a One-Point Adyice2) imniiiiimmmmnm.
Recording additional instruments during mixdown
1. Connect an additional musical instrument to the INPUT jack, and set the Input Level
switch accordingly. (All the REC SEL button will remain OFF.)
The instrument connected to Channel 1 will be recorded to L on the master recorder, and
the instrument connected to Channel 2 will be recorded to R.
2. Start mixdown.
Play the instrument during mixdown. The new instrument sound will also be combined
and mixed down.
Iltlllllllllllj|ltl!llll!llimi1lllllllllllllimil!tl!itlllllllllll!lllllll!!llllll!lllllllllllllllllll1imilllllllllllllllllllllllllllllll!lf f If nil
21

Fostex XR-3 Specifications

General

Brand	Fostex
Model	XR-3
Category	Recording Equipment
Language	English