9
UK
registered to your RX3, even if you
change alarms.
• The Halo Elite will now respond to your bite
alarms, whether or not your RX3 receiver
is in use.
PROCEDURE(4)
Registration with an I-COM Transceiver
This procedure should be followed if you own
radio-equipped bite alarms and an I-COM
Interactive Transceiver
1. Ensure that your bite alarms are
registered with the I-COM Transceiver (see
I-COM operating instructions for details)
2. Ensure your Halo Elite is switched OFF.
3. Switch on your I-COM Transceiver.
4. From the default editing screen, select the
bivvy light icon and press and hold down
the centre <C> of the navigation switch,
until the screen clears, leaving just the
bivvy light icon flashing. Release the
navigation switch.
5. Press and HOLD DOWN the button on
your Halo Elite remote keyfob, until the
I-COM reverts to its default editing screen
(approx 2 seconds) and emits a single beep.
6. Repeat step (4) above.
7. Switch on the Halo Elite. After a second
or so, the I-COM will revert to its default
editing screen and will emit a single beep.
The light on the Halo Elite will also give a
single flash.
8. You should now find that the Halo Elite
illuminates when any of your alarms are
triggered and can be switched on and off
from the remote keyfob.
9. You can also adjust the settings of your
Halo Elite, and switch it on and off, by
using your I-COM. See I-COM instructions
for full details.
Note -
• You do NOT need to repeat this procedure
if you purchase any additional bite alarms -
it is only necessary to register them with
the I-COM (see I-COM instructions for
details). The Halo Elite will automatically
respond to any bite alarm, which is
registered to your I-COM, even if you
change alarms.
• The Halo Elite will now respond to your
bite alarms, whether or not your I-COM
Transceiver is in use.
To Next Page
Loading...