8
UK
11. Alternatively, if you have registered less
than four alarms, the light will start
flashing again. Switch the Halo Elite off
and then on again.
12. You should now find that the light
illuminates when any of your alarms are
triggered and can be switched on and
off from the remote keyfob.
PROCEDURE(3)
Registration with an RX3 receiver
(including TXR+)
This procedure should be followed if you own
radio - equipped bite alarms and an RX3
receiver, or a TXR+ system.
1. Ensure that your bite alarms are
registered with the RX3 receiver (see
RX3 operating instructions for details)
2. Ensure your RX3 receiver and Halo Elite
are switched OFF.
3. Switch on your RX3 receiver.
4. Press and hold down the [ON/OFF] button
on your RX3. After about two seconds,
the top LED will start to flicker rapidly.
Release the [ON/OFF] button.
5. Press and release the “volume -“ button
on your RX3, four times, so that all four
LEDs are flickering.
6. Press and HOLD DOWN the button on
your Halo Elite remote keyfob, until the
four LEDs on the RX3 illuminate
constantly (approx 2 seconds) and the
RX3 emits a single “beep”
7. Hold down the [ON/OFF] button on your
RX3, until the topmost LED starts
flickering again.
Release the [ON/OFF] button.
8. Press and release the “volume -“ button
on your RX3, four times, so that all four
LEDs are flickering.
9. Switch on the Halo Elite. After a second
or so, the four LEDs on the RX3 should
illuminate constantly and a single beep will
be heard. The light on the Halo Elite will
also give a single flash.
10. You should now find that the light
illuminates when any of your alarms are
triggered and can be switched on and off
from the remote keyfob.
Note -
• You do NOT need to repeat this procedure
if you purchase any additional bite alarms -
it is only necessary to register them with
the RX3 receiver (see RX3 instructions for
details). The Halo Elite will automatically
respond to any bite alarm, which is
To Next Page
Loading...