21. Warning: the use of any non-recommended accessory can present a health risk.
22. Have the machine repaired by a qualified person. This machine is built according to relevant safety requirements.
Repairs must only be made by a qualified person using original spare parts, otherwise it may be very dangerous for
the user.
23. Keep these instructions.
ADDITIONAL SAFETY INSTRUCTIONS FOR THICKNESSERS
1. WARNING: do not use this machine before it is completely assembled according to the instructions.
2. IF YOU ARE NOT totally familiar with the use of thicknessers, seek advice from a qualified person.
3. MAKE SURE that the power cord is looked after and the instructions on the recommended electrical connection
are adhered to and that the machine is earthed correctly.
4. DISCONNECT the machine before making any adjustments or repairs.
5. NEVER turn the machine on before removing all objects on the table (tools, pieces of wood, etc.).
6. KEEP the blades sharp and rust-free.
7. CHECK feed rollers occasionally to be sure chips and sawdust are not lodged between any components. If rollers
are not seated firmly, the feed rolls will not hold stock firmly against the bed, allowing kickback.
8. NEVER use the machine without the guard.
9. KEEP fingers and hands away from the cutting zone.
10. NEVER put your hands under the chuck when the machine is underway.
11. KEEP fingers and hands away from the shavings exit. The pieces can exit at very high speed.
12. ALWAYS support the piece being planed adequately.
13. DO NOT start up the machine with the piece to be worked touching the chuck.
14. ENSURE that the piece to be worked is free from nails and other foreign objects which could cause physical
wounds or damage blades.
15. ENSURE that blades are fixed properly to the chuck, as is explained in the instructions for use, before starting
up the machine.
16. ALWAYS let the chuck reach its maximum diet before using the machine.
17. BEFORE leaving the machine after using it, ensure the working area is clean and tidy.
To Next Page
Loading...