3
20
System Information
This sub-menu is used to set up the standard BIOS features, such as the date, time and so
on. Use the arrow up/down keys to select an item, then use the <+> or <-> keys to change the
setting.
AMIBIOS
► System Time
This item allows you to congure the desired time. Use [ENTER] to enter the setting, then use
[TAB] to move forward a eld. Use [+] or [-] to input the value.
The three elds of the setting are <hour> : <minute> : <second> respectively.
► System Date
<weekday><month><date> <year> format.
Day—weekday from Sun. to Sat., this message is automatically displayed by BIOS (Read
Only).
Month—month from 1 to 12.
Date—date from 1st to 31st.
Year—year, set up by users.
Use [ENTER], [TAB] or [SHIFT-TAB] to select a eld. Use [+] or [-] to input the value.
► Primary IDE Master/Slave
While entering setup, BIOS automatically detects the presence of IDE devices. This item
displays the drive information of IDE devices.
► SATA Channel 1/2/3/4
While entering setup, BIOS automatically detects the presence of SATA devices. This item
displays the drive information of SATA devices.
► Halt On
This category determines whether or not the computer will stop if an error is detected during
powering up.
[All Errors] : All errors can result in system halt.
[All Errors But...] : All errors but keyboard or mouse or oppy can result in system halt. The
halt condition can be enabled/disabled in the next three settings.
► Keyboard
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
System Information
AMIBIOS Help Item
System Time [10 : 12 : 52]
System Date [Wed 01/20/2010] Use [Enter], [TAB]
or [SHIFT-TAB] to
► Primary IDE Master
[Not Detected] select a eld.
► Primary IDE Slave [Not Detected]
► SATA Channel 1 [Not Detected]
Use [+] or [-] to
► SATA Channel 2 [Not Detected]
configure system Time.
► SATA Channel 3 [Not Detected]
► SATA Channel 4
[Not Detected]
Halt On
[All Errors But ...]
Keyboard [Disabled]
Mouse [Disabled]
Model Name :A6GMV
BIOS Version :A11F1D03
System Memory Size:512MB
MAC Address :00-00-00-00-00-30
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
09