3
18
1.11. When the installation is completed, setup will prepare your compute for the rst use. Then
you can follow steps to select system settings, create an account, set a password...etc, until
the whole process is completed and enter
Windows 7 operating system
.
2. Install Drivers in Windows 7
2.1. When the Windows 7 is completely installed, you have to install the necessary drivers before
using the NETBOX. Take out the Windows 7 Install CD from the USB DVD-ROM drive, and
put the driver CD inside.
2.2. Waiting for a few seconds, the main menu will be displayed, click “Driver” to enter the Driver
menu shown as below:
2.3. Use these options to install all the drivers for your system. You must click "Intel Chipset Driver"
to install it rst. After that, you can click "One Click Setup" to install all the other drivers, or you
can click on each individual driver to install it manually.
2.4. After all the drivers are installed, you need to restart your NETBOX, then you can start using
it.
To Next Page
Loading...
Need help?
General
