Foxconn P43A Series - Superio Configuration; Onboard Floppy Controller

35
3
SuperIO Conguration
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port .
► IrDA Function
This item is used to enable/disable onboard infrared chip function.
► IrDA Duplex Mode
This item enables you to determine the transfer mode of the onboard infrared chip.Setting
values are: [Full Duplex], [Half Duplex].
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
SuperIO Conguration
OnBoard Floppy Controller
[Enabled] Help Item
Serial Port Address [Enabled]
IrDA Function [Enabled]
Allows BIOS to enable
IrDA Duplex Mode [Half Duplex] or disable oppy
controller.
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Enabled]