41
3
BIOS Security Features
► Change Supervisor Password
This item is used to install or change supervisor password.
After you input Supervisor password, it then will ask you to
input user password optionally.
If you have installed the supervisor password, the following
items will appear:
► User Access Level
This item is used to set user access level.
The available settings are:
[No Access]: Prevent user access to the setup utility.
[View Only]: Allow access to the setup utility but the elds can not be changed.
[Limited]: Allow only limited elds to be changed, such as date and time.
[Full Access]: Allow any eld to be changed except the
supervisor password.
► Change User Password
This item is used to install or change user password.
► Clear User Password
This item will be displayed only when a User Password was
set before. It is used to clear the user password.
► Password Check
When it is set to [Setup], a password is required to enter the BIOS setup; select [Always], a
password is required not only to enter BIOS setup, but also on each boot of your PC.
Enter New Password :
Enter New Password :
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
BIOS Security Features
Supervisor Password : Installed Help Item
User Password : Installed
Change Supervisor Password
Install or change the
User Access Level [Full Access] password
Change User Password [Press Enter]
Clear User Password
[Press Enter]
Password Check [Setup]
↑↓←→:Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help
F9:Optimized Defaults
[Press Enter]
To Next Page
Loading...
Need help?
General
