Enable/Setup Power Quality Response Modes
Please refer to the Advanced Configuration Guide.
Setup Region code (After initial commission)
Please short press button 12 times until the inverter screen show Setting, then long press button and enter the
password* , then press the button one time until it show Safety, then long press the button to enter the option list.
Check Firmware version, Region code and Power Quality Response Modes.
Please refer to the section 6.2.
Firm ware version: Please short press the button 8 times.
Region Code: Please short press the button 9 times.
Power Quality Response Modes: Please short press the button 10 times.
To Next Page
Loading...
