8
1. Turn on the TX9 remote control by pushing and holding the
power/send button for 2-3 seconds. You will see the LCD panel
light-up and display the sound list.
2. Use the sound up or down arrow button to cycle through the
sound list. Observe the black horizontal selector bar moving up
or down in conjunction with your button presses. When scrolling
through the sounds, the playlist will change by the page. The
first page will display sounds 000 – 005, page two displays 006 –
011, etc.
3. After highlighting a sound that you wish to play, press the
power/send button a single time. This action transmits a radio
signal to the Firestorm telling it to begin playback of the selected
sound. Notice that the sound number you selected is displayed
on the TX9 LCD panel on the bottom left side as well as the LCD
panel on the Firestorm.
4. Raise your volume level by pressing the volume up button. To
rapidly ramp your volume, press and hold the volume up button.
There are a total of 20 volume steps to choose from.
5. If you wish to mute or pause the sound, simply push the mute
button a single time. To make the sound play again, push the
mute button once more.
6. To switch sounds, follow the instructions in step 2.
7. To turn off the TX9, press and hold the power/send button for 4-
5 seconds. A message will appear displaying “Release key to turn
off transmitter.” As soon you as see the message, press the
power button.
To Next Page
Loading...