FOXTECH AYK-250 User Manual
©
2021 FOXTECH All Rights Reserved
7
Connect the Datalink and Check Flight Controller
5. Connection completed.
Although the accelerometer was calibrated already for the PNP version before shipping, please
calibrate it again since it might be affected in the transportation.
Under Initial Setup, select Accel Calibration from the left-side menu. Mission Planner will prompt
you to place the vehicle each calibration position. Press any key to indicate that the autopilot is in
position and then proceed to the next orientation.
The calibration positions are: level, on right side, left side, nose down, nose up and on its back.
1..Calibrate the Accelerometer
Click this button to begin accelerometer
calibration.
This accelerometer trim can be used
to level the HUD horizon.
11.t is important that the vehicle is kept still immediately after pressing the key for each step.
2.The level position is the most important to get right as this will be the attitude that your
controller considers level while flying.
To Next Page
Loading...
Need help?
General
