Notice
After connecting S-RTK100 with SLAM100:
① Make sure powering on the S-RTK100 in environment where has GNSS
signal (Open area);
② It will need about 5 min to run the time calibration and star search
automatically after powering on;
③ SLAM100 can work normally after the GNSS indicator flashes green light
or constantly on.
Note
① Use the S-RTK100 satellite signal receiver in the corresponding
frequency band according to local radio regulations, and comply with
local radio laws and regulations.
② Do not disassemble the antenna of this equipment.
③ Make sure the S-RTK100 is vertical to the ground (antenna up) when
using and placing.
④ Avoid using the S-RTK100 in an environment of obstruction or radio
interference.
⑤ Avoid block to the antenna when using;
⑥ Keep away from liquid such as water, oil, etc;
⑦ Avoid lightning.
©2022 FOXTECH All Rights Reserved 12
To Next Page
Loading...