NT204 OBDII/EOBD Code Reader User’s Guide_English Version_V1.00
completely checked and serviced by technicians and no vital information will be lost before
● Selecting Erase Codes from the diagnostic menu.
● To clear codes, make sure that the ignition key is switched to ON with the engine off.
● Erase Codes does not fix the problem that caused the fault! DTCs should only be erased after
correcting the condition(s) that caused them.
1. Use the UP/DOWN key to highlight Erase Codes from Diagnostic Menu and press the ENTER
Figure 4-6 Sample Diagnostic Menu Screen
2. Follow the on-screen instructions and answer questions about the vehicle being tested to
Figure 4-7 Sample Erase Codes Screen
3. Check the codes again. If any codes remain, repeat the Erase Codes steps.
4.3 Live Data
Live Data menu lets you view real time PID data from the electronic control module.
The View Data function allows real time viewing of the vehicle’s electronic control unit’s PID data,
including sensor data, operation of switches, solenoids and relays.
Menu options typically include:
To Next Page
Loading...
