52
Smart Diagnostic & TPMS Scanner TS7000 User's Manual V1.0
2. Press Stop button to create a record, then press OK to save the record
into Data Playback of Data Manager.
Figure 9-20 Sample To Stop Live Data Record Screen
9.2.4 Active Test
Active Tests, also known as Actuator Tests, are bi-directional diagnostic
tests on vehicle systems and component. The tests let you to use the
scanner temporarily activate or control a vehicle system or component, and
when you exit the test, the system/component returns to normal operation.
Some tests display a command to the operator. For example, if “Press Brake
Pedal” displays, the operator has to press and hold the brake pedal and then
continue. The sequence, number and type of tests are dictated by the control
module.
On some systems, the actuator tests cannot be restarted until the ignition
key is switched off for some time. Alternatively, briefly start and run the
engine, shut down, turn the ignition to the run position, then re-initiate the
actuator tests.
IMPORTANT
The tests activate a component, but they do not check if the component is
working correctly. Make sure the components to be tested are in good
condition and correctly mounted.
NOTE
Available tests depend on the control module under test and the vehicle
itself.
To start a test:
To Next Page
Loading...
