66
Smart Diagnostic & TPMS Scanner TS7000 User's Manual V1.0
11.2 Trigger Operations
The sensor trigger function allows activating of TPMS sensor to view sensor
data such as sensor ID, tire pressure, tire temperature, sensor battery,
sensor position, and sensor frequency.
To Trigger TPMS sensor
1. Tap Trigger Tab.
2. Tap the desired wheel position on the vehicle thumbnail. Hold the tool
with the symbol (in the top right corner) close to the tire sidewall near
the valve stem, and then press the Trigger button. The tool will send low
frequency signal to trigger the sensor.
3. The sensor data of the selected wheel will display on the table of the
screen once the sensor is successfully activated and decoded.
Figure 11-7 Sample Trigger TPMS Screen
NOTE:
The Display Tablet will perform TPMS check in a sequence of FL (front left),
FR (front right), RR (rear right), RL (rear left) and SP (spare, if any).
4. Wheel with a feedback icon, red or green vertical rectangle, indicates
sensor trigger has been finished. Refer to Table 11-1 for details.
To Next Page
Loading...
