73
Smart Diagnostic & TPMS Scanner TS7000 User's Manual V1.0
To Automatic Create
1. Tap Programming tab.
2. Select the specific wheel on the screen.
3. Tap the Automatic Create functional button on the screen.
4. Place the proper Foxwell sensor T10 near the top right of the Display
Tablet to write the new created sensor ID into the Foxwell sensor T10.
Figure 11-14 Sample Automatic Create Function Screen
After programming is finished, the new programmed Sensor ID will display
on Column 2 of the table.
11.2.4 Copy by OBD
This function allows users to write the saved sensor information into Foxwell
sensor T10 after performing Copy by OBD function, the sensor ID will
appear on the table in Programming screen. Select the specific wheel on the
screen, and then tap Copy by OBD button.
To Next Page
Loading...
