SECTION 5 - R EMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
51
CURSOR SERIES
Print P4D32C006 E Base - 03/2015
Figure 152
60568
Key the sealing gasket (1) onto the crankshaft, fit the keying
device 99346260 (2) and while tightening the nut (3) drive in
the sealing gasket.
Figure 153
α
49037
Position the flywheel (1) on the crankshaft, lubricate the thread
of the screws (2) with engine oil and screw them down.
Block rotation using the tool used to fasten the engine flywheel
housing 99360351 (3); Using the torque wrench (4), tighten
the screws (2) to the torque indicated in the table.
Ref.
No. Description
Tightening
torques
(2) 8
ScrewsM18X1.5X72
Step 1 120 ± 6 Nm
Step 2 90 ˚
NOTE Lubricate the screws with engine oil.
Figure 154
α
49036
Tighten to angle with wrench 99395216 (1).
Figure 155
α
225022
Observe the order of tightening indicated in the diagram.
To Next Page
Loading...
