52
SECTION 5 - R EMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Figure 156
185252
Apply the tool for engine flywheel rotation 99360321 (7) and
the specific spacer 99360325 (8) to the gear housing (3).
NOTE The arrow shows the direction of rotation of the
engine when running.
With the aforementioned tool, turn the flywheel (1) in the
direction of the engine rotation so as to bring cylinder piston
1to54˚ before the T.D.S. during compression (cylinder 6 in
discharge phase).
NOTE This condition occurs when the hole with two
notches (5) on the engine flywheel (1), can be
seen through the small inspection window (2).
Figure 157
71774
Check that the tool for positioning the T.D.C 99360612 (1),
through the seat (2) of the engine speed sensor , enters the
hole (3) in the engine flywheel (4). in
in this condition, the flywheel is in the reference position
(piston no. 1 to 54˚ before T.D.C.).
If this is not the case, turn and adjust the engine flywheel (4)
appropriately.
Remove tool 99360612 (1).
Figure 158
225058
Lubricate the seal (3) and fit it on the shoulder plate (2).
Fit the shoulder plate (2) with the sheet metal gasket (1) and
tighten the screws (5) to the torque shown in the table and in
the order indicated in the next figure.
Ref.
No. Description
Tightening
torques
(5) 5
Screws M8 X 1.25 X
25
24.5 ± 2.5 Nm
To Next Page
Loading...
