34
Drain/suck condensation from fuel tank
Clean the turbocharger
Check the efficiency of the pre-post heating system
Adjust play in valves-rocker arms
Injector calibration
Overhaul injection pump
MOVING THE ENGINE
The operations necessary to disconnect and subsequently
reconnect the engine must only be carried out by technicians from
Authorised Service Centres.
When lifting the engine only, use the U-bolts indicated in this manual
in the section ENGINE TECHNICAL DATA and marked on the
engine with special stickers.
Lifting must be carried out using a rocker arm that keeps the metal
cables supporting the engine parallel, using all the U-bolts provided
simultaneously; the use of a single U-bolt only is not allowed.
The engine lifting system must have a capacity and size suited to the
weight and dimensions of the engine; check that there is no
interference between the lifting system and the engine components.
Do not lift the engine before removing the transmission members
that are coupled to it.
DISPOSAL OF WASTE
The engine is made up of parts and elements that, if discarded, may
cause damage to the environment.
The materials listed below must be handed over to specialised
Collection Centres; the laws in force in the various Countries
foresee severe penalties for transgressors:
Starter batteries.
Used lubricants.
Mixtures of water and antifreeze.
Filters.
Additional cleaning materials (e.g. greasy or fuel-soaked cloths).
WARNING
The operations listed below must only be carried out by qualified staff
from the IVECO MOTORS Service Centres or by the Manufacturer's
staff.
The methods used to perform them are described in the Technical
and Repair Manuals.
To Next Page
Loading...
