18
REQUIREMENTS
Do not disconnect the battery supply while the engine is running.
Do not perform arc welding near the engine without first removing
its electrical wiring.
After all maintenance operations that require disconnection of the
batteries, make sure the clamps have been securely reconnected
on the poles.
Do not use a battery charger to start the engine.
Do not paint the devices, components and electrical connectors of
the engine equipment.
Electrically disconnect the battery/batteries before performing any
electrical work.
Contact the Manufacturer before installing any electronic
equipment.
In the event in which fuel is used with a sulphur
percentage greater than 0.5%, or oils are used which
do not meet the specifications in the section FLUIDS,
then the replacement frequencies of the engine oil,
engine oil filter and blow-by filter must be halved, or
suitably adjusted, in accordance with the use and
operating conditions of the engine; please consult the
personnel in charge of maintenance operations for
appropriate advice.
The operations described above require the use of
specific tools which guarantee safe and effective
results.
It is recommended that such operations are carried out
by qualified personnel of the FPT Technical Service
Network.
The unscheduled maintenance operations described in
the relative table are under the exclusive responsibility
of qualified personnel in possession of suitable
technical information and equipped with suitable work
tools and protective devices. The instructions for their
fulfilment are contained in the FPT technical and repair
manuals.
Do not perform any operation that would change the
calibration of the injection pump.
It was adjusted during the engine test phase and based
on its destination.
To Next Page
Loading...
