FPT NEF67TM7 - PRELIMINARY USE CHECKS; Fluid Level and Air Filter Inspection

9
ENGLISH
E
N
G
L
I
S
H
 USE
PRELIMINARY CHECKS
Each time before starting the engine:
 Check and top up the level of the technical fluids, if necessary (fuel,
engine oil and coolant).
 Make sure that the air intake filter is not obstructed or clogged and
check, at the same time, that the visual indicator (1) on the filter is
not showing the “red” signal. The air filter clogging visual indicator
(1) signals when it is necessary to carry out maintenance in order
to protect and optimize filter operation. The sensor (1) remains
locked in the alarm position ("red") until it is reset.
Note: the required procedures for filter cleaning are specified
in the chapter CHECKS AND MAINTENANCE.
14_207_N
ATTENTION!
Make sure that the environment where the engine will
operate is free of combustible vapours or gases. Make
sure that there is sufficient ventilation and a suitable
exhaust gas extraction system for closed environments.