FPT NEF67TM7 - OIL FILTER REPLACEMENT; Filter Specifications & Installation

25
ENGLISH
E
N
G
L
I
S
H
Change oil filter
Only use filters with the following specifications (see the section
FREQUENCIES):
- degree of filtering < 12 μm
- filtering efficiency 99.5% (ß > 200).
Only proceed when the engine is not turning and is at low
temperature so as not to run the risk of burns.
 Proceed with the emptying of the spent oil (see paragraph
CHANGE ENGINE LUBRICANT OIL).
 Place a container for collecting the spent oil under the filter support
(1).
 Remove the filter (2) by unscrewing it from its relative support.
 Replace the filter element and the O-ring seal contained inside the
filter (2).
 Carefully clean the surfaces of the support (1) in contact with the
O-ring seal.
 Moisten the O-ring seal of the new filter with oil.
 Screw the new filter (2) onto the support (1).
Eliminate the consumables and any materials in
contact with them (for example, filters) in accordance
with current regulations.
The FPT Technical Service Network workshops are
equipped for this purpose.
14_210_N