14
HEPA filter
• Install the HEPA (High Efficiency Particulate Air), the unit will only operate under fan mode, and the
HEPA light will illuminate.
• Make sure you have fitted the HEPA filter as indicated in below picture.
Removing the collected water
There are two ways to remove collected water.
A. Use the bucket
• When the bucket is full, the unit will automatically stop running, and the Full indicator light will flash.
• Slowly pull out the bucket. Grip the left and right handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the floor because the bottom of the bucket is uneven.
Otherwise the bucket will fall and cause the water to spill.
• Throw away the water from the water outlet and replace the bucket. The bucket must be in place
and securely seated for the dehumidifier to operate. The machine will restart when the bucket is
restored in its correct position.
Note:
• When you remove the bucket, do not touch any parts inside of the unit. Doing so may damage the
product.
• Be sure to push the bucket gently all the way into the unit. Banging the bucket against anything or
failing to push it in securely may cause the unit not to operate.
• When you remove the bucket, if there is some water in the unit you must dry it.
To Next Page
Loading...