Operating instructions
Parquet floor sander COBRA C
with gentle lifting lever
9
3.2 Technical data
Single-phase AC motor 230 V, 50 cps
Motor power 2500 W
Sanding drum speed 2100 rpm
Sanding width 200 mm
Sanding belt dimensions 200 mm x 750 mm, endless
Machine weight 78 kg
3.3 Safety and machine protection facilities
COBRA C is equipped with an
- overcurrent cutout and an
- no-volt release
The overcurrent cutout protects the machine from damage and persons from endangering in the
case of short circuits.
The no-volt release prevents uncontrolled restart of the machine after power failure. The motor
will not restart automatically when the power returns, it will have to be switched on again.
4 Proper use
The parquet floor sander COBRA C is suitable for dry sanding of parquet and plank
floors. No other use is allowed.
Caution!
Never use COBRA C for wet procedures (mortal risk from electric shock)!
To Next Page
Loading...