TRANSLATION FROM ORIGINAL PRODUCT MANUAL
© Copyright 2023
Franka Emika GmbH
Frei-Otto-Straße 20
80797 Munich
Germany
This document and extracts of it may only be reproduced or made available to third parties with the explicit
authorization of Franka Emika GmbH.
The content of this document has been carefully checked against compliance with the hardware and software
described. However, discrepancies cannot entirely be ruled out, which is why we assume no liability for
complete compliance.
In the interest of our customers, we reserve the right to undertake improvements and corrections to
hardware, software, and documentation at any point in time without notice.
We are always grateful for your feedback at documentation@franka.de.
The German documentation is the ORIGINAL DOCUMENTATION. Other languages are translations of the
original document.
Complementary documents to this product manual are:
• Datasheet Franka Research 3 (Document number: 120020)
• Getting Started guide (Document number: 110030)
• Labeling material for the integrator (Document number: 110040)
• Drilling template (Document number: 110050)
Document name: Product Manual Franka Research 3
Document number: 120010
Release Version: 1.0 (Sept. 2023), valid for Franka Research 3 with system version 5.3.1
Change Log:
To Next Page
Loading...
