Franke FCE60M5B - Electrical Connection; Fitting on a Power Supply Cable

4
5
m
m
．
5
6
0
m
m
．
5
9
5
595
5
65
2
2
595
565
595
2
0
0
M
I
N
2
2
2
0
0
M
I
N
4
5
m
i
n
4
5
m
i
n
4
5
m
i
n
4
5
m
i
n
4
5
m
i
n
594
5
9
4
5
4
7
.
8
5
7
7
.
2
2
1
5
9
4
5
9
4
5
4
7
.
8
5
7
7
.
2
2
1
N. B :Installation
in compliance with the consumption declaration
In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed .Installing the oven so that it rests on two
strips of wood is preferable .If the oven rests on a continuous ,flat surface ,there must be an aperture of at least 45×560mm .
The panels of the adjacent cabinets must be made of heat-resistant material .In particular ,cabinets with a veneer exterior must be
assembled with glues which can withstand temperatures of up to 100℃.
In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it has been installed.
All parts, which ensure the safe operation of the appliance, must be removable only with the aid of a tool.
To fasten the oven to the cabinet, open the door of the oven and attach it by inserting the 4 wooden screws into the 4 holes located on
the perimeter of the frame.
Electrical Connection
Those ovens equipped with a three-pole power supply cable are designed to operate with an alternating current .The wire for earthling the
appliance is yellow-green in color.
Fitting on a Power Supply Cable
Opening the terminal board:
· Using a screwdriver ,prize the bolt on the side tabs of the
terminal board cover ;
· Using a screwdriver unhooking the no.2fixing hooks,
15 AMP
Fuse Required