Franke FIH3210 - Start cooking

  +RZWRXVH     

  6WDUWFRRNLQJ

Touch the ON/OFF controlˈAfter power on, the buzzer
beeps once, all displays show “–” or “– –”, indicating
that the induction hob has entered the state of standby
mode.
Place a suitable pan on the cooking zone that you wish
to use.
• Make sure the bottom of the pan and the surface of
the cooking zone are clean and dry.
Touching the heating zone slider control ,

and a
indicator next to the key will flash.
Select a heat setting by touching the slider control
• If you don’t choose a heat setting within 1 minute,
the Induction hob will automatically switch off. You will
need to start again at step 1.
• You can modify the heat setting at any time during
cooking.
,IWKHGLVSOD\IODVKHV        DOWHUQDWHO\ZLWKWKHKHDWVHWWLQJ
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you’re using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display “ ” will automatically disappear after 1 minutes if no suitable pan is placed on
it.

power up
power down