7
FIRST TIME USE
Clean your hob with a damp cloth, and then dry the surface thoroughly. Do not use detergent which
risks causing blue-tinted colour on the glass surface.
INSTALLATION INSTRUCTIONS
Check the appliance for damage after unpacking it, and don’t connect the appliance if it has been
damaged in transport.
Only a licensed professional may connect the appliance – damage caused by incorrect installation is
not covered under the warranty.
Ensure that the panels of the cabinetry around the Appliance are heat resistant, and the glues and
materials can withstand temperatures of at least 90 degrees Celsius.
Remove all labels and adhesives from the ceramic glass prior to use. The ceramic glass cannot be used
as working surface, or chopping board or for anything other than cooking.
The appliance must be grounded and must not be controlled by a separate remote control system.
This appliance must not be used in close proximity to dishwasher or dryer, as steam can damage the
surface.
The installation comes under the exclusive responsibility of specialists.
The installer is held to respect the legislation and the standards enforced.
How to stick the gasket:
The gasket supplied with the hob avoids all infiltration of liquids in the cabinet.
This installation has to be done carefully, in conformity of the following drawing.
Stick the gasket (2) two millimetres from the
external edge of the glass, after removing the
protection sheet (3).
To Next Page
Loading...
Need help?
General
