EasyManua.ls Logo

Franklin Electric INLINE 1100 SPECPAK - User Manual

Franklin Electric INLINE 1100 SPECPAK
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
INLINE 1100 SPECPAK
Owner's Manual
Meets the Requirements of
NSF/ANSI 372

Questions and Answers

  • A
    amy50Aug 21, 2025
    How to troubleshoot Franklin Electric INLINE 1100 SPECPAK Water Pump PLC screen that does not turn on?
    • E
      Emily HernandezAug 21, 2025
      If the PLC screen of your Franklin Electric Water Pump does not turn on, it might be due to several reasons. The site power to the control panel may be interrupted, so verify that site power is live to the panel. The main control panel disconnect may be in the OFF (0) position; turn the control panel disconnect to the ON (1) position. The main fuses or the fuses for the PLC may be blown; check the fuses and replace if necessary. Alternatively, the PLC may be malfunctioning, so replace the PLC.
  • M
    Mark BeardAug 31, 2025
    Why is there noise in the discharge header of my Franklin Electric INLINE 1100 SPECPAK?
    • D
      Dawn MarshallAug 31, 2025
      If you notice noise in the discharge header when the Franklin Electric Water Pumps are operating, it could be due to an air pocket in the discharge header. Remove the air in the manner described in the set up instructions.
  • S
    Susan RussellNov 10, 2025
    What to do if Franklin Electric Water Pump does not turn on?
    • L
      Lance SantosNov 10, 2025
      If the green power light for the Franklin Electric Water Pump is not on, the site power to the control panel may be interrupted. Verify that site power is live to the panel. Also, the main control panel disconnect may be in the OFF (0) position, so turn the control panel disconnect to the ON (1) position. The pump power disconnect may be in the OFF position, so turn the pump disconnects to the on position. The main control panel fuses or the fuses for the pump may be blown; in this case, check fuses and replace if necessary. In addition, the PLC may be malfunctioning, so replace PLC. If the Green power light for the pump IS ON, the pressure setpoint may be met and there is no current demand, so no action is required. Finally, the enable signal wiring from the controller to the pump may be ...

Franklin Electric INLINE 1100 SPECPAK Specifications

General IconGeneral
ModelINLINE 1100 SPECPAK
Horsepower1.5 HP
Max Flow Rate25 GPM
MaterialStainless Steel
Pump MaterialStainless Steel
Warranty1 Year
TypeWater Pump
Voltage230V
Pump TypeBooster Pump

Related product manuals