ASSEMBLY INSTRUCTIONS:
(Refer to the Parts Guide).
STEP 1
[1A] Make sure the ground is soft and clear of rocks or any other obstructions. Insert Ground
Sleeve Pole (#3) into the Ground Sleeve (#4) and twist into ground.
NOTE: To assemble your set in a more permanent fashion (not shown), secure the ground sleeve
into a one foot square base of concrete or drill a 12” deep hole in a hard surface.
[1 & 1B] Place the Bottom Pole (#2) onto the Ground Sleeve (#4) until the button locks into place.
STEP 2
[2A] Attach the Eyebolt (#6) into the Top Pole (#1). Attach the Snap Clip with Tetherball (#5) to
the Eyebolt (#6). NOTE: The ball should hang approx. two feet from the ground.
[2 & 2B] Place the Top Pole (#1) onto the Bottom Pole (#2).
STEP 3
The court should be set up in a circle 20 feet in diameter which is divided into two playing zones.
127(If dividing the circle in degrees, draw a straight line between 60° and 240°, and also
between 120° and 300° (between 2 and 8 o’clock and between 4 and 10 o’clock of a clock’s dial).
:$51,1* It is recommended that the tetherball be stored indoors after use. Do not hang from
or pull on the pole as permanent damage may result.
Play Zone
Neutral Zone
Play Zone
Neutral Zone
To Previous Page
Loading...
