LGT100 Rev0309
18
Install Pedestal Mount Models 570, 580
When positioning a pedestal mount light ensure that the lamphead will clear all
obstructions.
1. Place the light in position to check for t and freedom of operation.
2. Mark the footprint of the mounting ange/bracket.
3. Drill mounting holes.
4. Ensure that approved strain relief for the wiring is installed.
5. Secure the mounting ange/bracket. Use 5/16-18 or 1/4-20 SS hardware. Install
a backing plate if necessary for a sturdy mounting.
Wiring
12/24 VDC
Connect the BLACK wire to GROUND.
Connect the RED (or WHITE) wire to POWER.
120/240 VAC
Connect the SILVER BRAID or GREEN wire to chassis GROUND.
Connect the WHITE wire to RETURN.
Connect the BLACK wire to POWER.
OPA570
FCA580
To Next Page
Loading...