LGT100 Rev0309
28
Bulb Replacement NightMaster
1. Ensure power is OFF and the lamphead is cool to the touch prior to replacing
the bulb.
2. Ensure the replacement bulb has the same voltage and wattage rating.
3. Loosen the two screws on each side of the lamphead. Open the glass cover
(the gasket may also come off).
4. Slide the bulb sideways into the spring contact and lift it out from the opposite
side.
Note: When handling the new bulb avoid touching it except on the at seal at
either end. (Grease or oily ngerprints can cause damage the quartz bulb.) If
the bulb is accidently touched, gently wipe it clean with alcohol.
5. Check both lamp base contacts to be sure they are perfectly clean.
6. Push one end of the bulb into the spring contact until the other end can be
placed into the opposite contact. Rotate the lamp back and forth about its axis
to ensure adequate seating of contacts.
Caution: Do not operate the light with the front glass removed.
7. Ensure the gasket is in place. Close the glass cover and tighten the two screws.
Do not over tighten the screws.
Note: Bulb life is extended when the bulb is mounted in a horizontal
position.
Bulb Replacement Triple Cluster
12 Volt, 100 Watt, PAR 46 Bulb
1. Ensure power is OFF and the lamphead is cool to the touch prior to replacing
the bulb.
2. Ensure the replacement bulb has the same voltage and wattage rating.
3. Remove the three screws (newer installations have one screw) and the collar
that hold the bulb in place.
4. Remove the three wires one at a time from the bulb and connect them to the
same terminal on the new bulb.
5. Put the new bulb in position and set the collar in place.
6. Install and tighten the screw(s).
To Next Page
Loading...