Maintenance
Interval Inspections
Every 15 Flights
ALTA X is designed to be as low-maintenance as possible. It is recommended to check ALTA
X’s fasteners regularly. This check should occur roughly after every 15 flights. To check ALTA
X’s fasteners, apply a tightening torque to each fastener on the chassis using the supplied
hex drivers. The fasteners should not slip.
Inspect Fastener Tightness
Check the tightness of the following fasteners:
Motor mount bolts
Boom clamping bolts
Prop hub bolts
Prop bolts
Top and bottom chassis bolts
Closeout panel bolts
FPV camera mounting plate bolts
Boom stay attachment bolts
GPS/Compass mounting bolts
{% hint style="info" %} If a fastener does slip, tighten it using the methods described in the
Fastener Installation section. Do not apply additional thread locking compound unless the
fastener has repeatedly come loose. {% endhint %}
Every 15 Flight Hours
Inspect Fastener Tightness
To Next Page
Loading...
