Check the tightness of the fasteners as described above.
Inspection Wear Components
Inspect the following items. Replace if worn.
Propeller blades - Chips, cracks, or deep scratches
ActiveBlade bumpers
Broken or crushed
Inspect Boom Ring Latch Tightness
Check boom latching tightness by closing the latch. There should be a firm closing force and
click. Adjust the tension by using a 2.0mm hex wrench on the set screw located in the rear of
the latch link.
Replacement of Parts
Spare or replacement parts are available for sale separately at freeflysystems.com. Please
refer to the store for a current listing of all available spare parts.
{% hint style="warning" %} Use Of Threadlocker
Bolts and screws used in the daily use of this aircraft do not require threadlocking
compound. This includes the screws holding on the battery trays, vibration isolation system
and the Skyview landing gear parts.
However, for the structural fasteners described in parts of this section blue Loctite 243
compound or equivalent is required. Apply sparingly to the threads before insertion. {%
endhint %}
{% hint style="warning" %} Fastener Installation
The Freefly hex drivers included with ALTA X are designed to limit the torque that can be
applied to each bolt or screw and help prevent stripping the fastener head.
Thread all fasteners into their respective holes until snug (when the fastener head bottoms
To Next Page
Loading...
