29
ADJUSTING THE DRIVE BELT
If the pedals slip while you are pedaling, even while the
resistance is adjusted to the highest setting, the drive
belt may need to be adjusted. Before you adjust the
drive belt, unplug the power adapter.
Remove the two Screw Caps (55) from the Shield
Cover (54). Next, remove the two indicated M5 x 12mm
Truss Screws (68). Then, remove the Shield Cover.
Next, locate the M8 Locknut (90) on the Eyebolt (8).
Tighten the Locknut until the Drive Belt (16) is tight.
When the drive belt is properly tightened, reattach the
parts that you removed.
55
55
68
54
68
8
90
16
To Next Page
